• Voltage
    10 - 30Vdc

    Current
    250mA @12Vdc - 130mA @24Vdc

    Solenoids
    Solenoid rated for continuous use

    Electrical protection
    Polarity and back EMF protected

    Monitoring
    Solenoid Monitor - 1 amp NO/NC microswitch
    Door / Latch Monitor - 1 amp NO/NC microswitch

    Holding force
    1300kg static strength rating

    Endurance
    1,200,000 cycles endurance rating @ 25kg pre-load
    2,500,000 cycles general durability without pre-load conditions

    Latching
    Suitable for 15mm latch with 3mm door gap

    Environment
    Operational temperature range - 20C to +60C

    Body
    Solid Stainless Steel Construction

    Keeper
    Stainless Steel

    Specification Statement
    The electric strike should be fully monitored and have independent door / latch and solenoid monitor switches. Holding force for the strike should be not less than 1300kg.

    Where Power to Lock and Power to Open functions may be required in the same building, a single electric strike should be interchangeable from either fail safe or fail secure from the rear of the strike.

    The electric strike should not consume current greater than 250mA @ 12Vdc and have a solenoid rated for continuous use. A fire rating not less than 4 hours is required where applicable. The strike must be capable of operating with up to 25kg of pre-load pressure applied to the keeper, be tested to 2.5 million operations and carry a minimum warranty of 5 years.